Home > Products > Gear Coupling > Gear Coupling
CLZ Type Gear Coupling
  • CLZ Type Gear Coupling
  • CLZ Type Gear Coupling
  • CLZ Type Gear Coupling

CLZ Type Gear Coupling

    Gear Coupling

    · Model: CLZ Type

    · Norminal Torque: 710kN. M - 1000000kN. M

    · Allowed Rotation Sppeed: 3780rpm -300rpm

    · Connection: Keyway & Shaft hole 

    · Shaft Hole Diameter: 18mm - 560mm

    · Shaft Hole Length (Y): 42mm - 8000mm

    · Applications: Metallurgy, mining, lifting and transportation industries, petroleum, chemical, general machinery and other heavy machinery shaft drive.


inquire Now
  • Description

    CLZ-type gear coupling bearing impact performance is good, but the tooth surface contact stress and tooth root bending fatigue strength requirements, it is suitable for connecting two horizontal axis drive shaft, with a certain compensation for the relative deviation of the performance of the two axes, passing nominal torque of 710-1000000N.m. CLZ-type gear coupling is a removable rigid coupling, made by two shell with internal teeth and two external teeth of the sleeve, the sleeve and shaft are connected by key, the two shells connected with bolts Integrally, between the shell and sleeve with a seal ring.


    CLZ图纸.jpg

    CLZ1.jpg

    CLZ2.jpg

    CLZ3.jpg

    Maintenance Method:

    Gear coupling maintenance generally is in accordance with the following methods:

    1. Check the coupling tooth surface meshing situation, the contact area along the tooth height of not less than 50%, along the tooth width of not less than 70%, tooth surface shall not have serious pitting , wear and crack.

    2. The coupling outside the ring beating no more than 0.03mm, round face round beating is no more than 0.02mm. 

    3. If need to remove the ring gear, you must use special tools, no beating, so as not to bend the axis or damage. When the equipment is installed, the ring gear should be heated to about 200 ℃ and then installed on the shaft. External ring gear and shaft interference is generally 0.01 ~ 0.03mm.

    4. Back to the middle of the cylinder or other components should be based on the original mark and data assembly.

    5. With a torque wrench evenly tighten the bolt.

FREE INQUIRY
CONTACT US
  • Tel: +86 523 8463 4389
  • Fax: +86 523 8450 5216
  • Factory address: No.11 Fuyang Road, ChengNan Industry Park, Jingjiang, Taizhou, Jiangsu, China.
  • Tel: +86 512 8616 3031
  • Fax: +86 512 8616 3026
  • E-mail: sales@hdcoupling.com
  • Head office address: Room 1516, Modern Plaza B, No.8 Weiye Road, Kunshan, Jiangsu, China.

Copyright © Jingjiang Huading Machinery Manufacturing Co., Ltd. All Rights Reserved    

sitemap